IC Archives - In Compliance Magazine

EMC Design in the IC Environment with Respect to ESD and Burst

Today's integrated circuits (IC) are very sensitive to disturbances. Fast pulses which were not perceived by slower ICs in the past may now lead to serious disturbances or even total failure. The characteristic... Read More...

Melexis MLX92242 IC | In Compliance Magazine

Melexis Highly Integrated EOL Programmable Hall Sensor Supports Direct Connection into Automotive/Industrial Designs without Need for PCB or Discrete Components

Melexis Technologies NV has followed up the success of its initial MLX92242 Hall effect switch/latch IC, which offers end-of-line (EOL) programmability and support for 2-wire operation, with a fur... Read More...

Melexis-PR33_HRES | In Compliance Magazine

Low Pin Count N-FET Pre-Driver from Melexis Targets Automotive High Current DC Motor Applications

To complement its successful brushless direct current (BLDC) pre-driver portfolio and address conventional DC motor applications, Melexis introduces the MLX83100 N-FET pre-driver IC. Offered in a compact 28-pin... Read More...

Wirelessly Powering IoT With 5G Network

Polymer Film Can Limit Electromagnetic Interference

Using Nanomaterials to Create a Passive Dual-Mode Heating and Cooling Device

Scientists Develop Highly Efficient Supercapacitor That Could Rival Batteries

Material Found to Block Electromagnetic Waves

Trading Electrons for Light Beams

FCC Expands Space Access for IoT Support

EU Commission Seeks to Expand RED Cybersecurity Requirements for IoT Devices

EU Commission Updates List of Harmonized Standards for Toys

Automotive EMC Case Study: HMI Graphics Influence on Radiated Emissions

Introduction to Validation Test Concepts in a Mixed Signal ASIC

EMC Design Techniques for Electric Vehicle DC-DC Converters

Capacitors: Theory and Application

System-Level Grounding

SCIF and Radio Frequency Secured Facility Design

Design Considerations in Spread Spectrum Modulation for CISPR 25/CE Testing

Radiated Emission Measurements in the Semi-Anechoic Chamber at 3, 5, and 10 m Distance: Results and Empirical Estimates

Application of Thrifty Test Equipment for EMC Testing

Assessing Advanced Driver Assistance Systems (ADAS) in Vehicles

Simulation-Based Testing for Early Safety Validation of Robot Systems

Caster Contact: The Achilles Heel of ESD Floors

Will 4% Steps Find Radiated Susceptibilities?

How Grounds Affect the Peak Voltage Due to Lightning

Harmonic Measurement for IEC 61000-4-3 and other Radiated Immunity Standards

Expected Service Life of Medical Electrical Equipment

Toward Standardization of Low Impedance Contact CDM

The American National Standards Committee on EMC – C63®

10 Questions to Ask When Buying a Used Test Chamber

Capacitors: Theory and Application

Ohm’s Law Also Applies to ESD‑Induced Heat Pulses

RF Tech Tip: BNC Versus Threaded Connectors

Troubleshooting EMC Problems Like an MD

Avoiding Supply Chain Disruptions of Safety-Critical Recognized Components

Controlling Static Electricity: A 50-Year History

EMC Design in the IC Environment with Respect to ESD and Burst

Melexis Highly Integrated EOL Programmable Hall Sensor Supports Direct Connection into Automotive/Industrial Designs without Need for PCB or Discrete Components

Low Pin Count N-FET Pre-Driver from Melexis Targets Automotive High Current DC Motor Applications

Tagged IC